napsgeargenezapharmateuticals domestic-supplypuritysourcelabsSarms for Saleunclez.rueudomestic

Napsgear: 6 Common Dumbbell Lateral Raise Mistakes

Richardbrown

V.I.P.
Gold
gearpic.jpg


Larger delts are a top priority for all lifters since they give the appearance of a smaller waist, enhance the separation of the upper arm from the lower arm, and add the type of shoulder cap that indicates you're a serious lifter. Your clothes' slight added stretch too, perhaps? That is what I'm referring to!

You might be beginning your shoulder workout with overhead presses like many lifters do. It works. The greatest technique to isolate the middle delts in the lateral (side) plane, however, is to include lateral-raise exercises.

Lateral raises are hugely popular, and frequently doing them incorrectly in several ways. Here are 6 ways to mess up the standing dumbbell lateral raise, the most popular variant.


Mistake 1: Altering the Angle of Your Elbow Throughout the Movement
When performing a lateral raise correctly, you should bend your elbows just slightly and keep them bent for the duration of the set. Your elbows should maintain the same angle at the peak and bottom of each rep.

The isolation of the middle-delts will be compromised if you begin opening and closing at the elbows, which will involve the triceps. The weights should ideally follow more of an arc as you raise them rather than a straight line. Watch yourself or have someone else watch you while you make this action; if you're paying attention, it's not difficult to fix the mistake.


Mistake 2: Lowering the Weight Too Low
Keeping the middle delts tense during each rep is the best strategy to develop these target muscles. You are not placing any stress on your delts at all if you lower your hand all the way down till it is hanging by your side or in front of your leg.

Furthermore, the supraspinatus, a rotator cuff muscle, starts the movement before the middle delt head when you begin lifting from this fully extended position. This indicates that your target muscles aren't being worked during the initial degrees of your raise.

Stopping the movement with your hand a few inches from your side is your best option. This will make it little more difficult to bring the weight back up, which is what you want, right? Lower the weight all the way if you do want to work your supraspinatus a little. But when you lift it again, watch out for using too much force or moving erratically, both of which might result in harm.


Mistake 3: Leading with Your Wrists
Beginners frequently make the error of wagging the weights up and down without extending their elbows. In that regard, the upper arms don't have a wide range of motion, which can negate your gains in the middle delts. You should constantly "lead with your elbows" to ensure that they complete the whole range of motion.

The advantages of this middle-delt movement are essentially lost if your elbows don't move much. Your elbows are only approximately halfway up, even though your hand is where it should be at the top. Always lead with your elbows, okay?


Mistake 4: Only Raising to Shoulder Height
Even though the middle delt's range of motion extends further aloft, people typically do lateral lifts to a height of roughly shoulder height. You can increase the amount of contraction in your middle delts by going up to a point about 45 degrees above parallel. (You'll also somewhat activate your upper traps.)

You'll probably need to reduce your weight when you can move above your shoulders. You might think about doing a few sets with bigger weights at shoulder level, then a few more with somewhat lighter weights at a 45-degree angle above parallel.

Lifting above your shoulders is usually not a smart idea if you have shoulder impingement or soreness. If this is a problem, consult a sports medicine physician before attempting to increase your range of motion.


Mistake 5: Extending Your Arms Fully While Locking Them
On rare occasions, you'll see someone performing lateral lifts with their arms fully extended. It appears as though the individual is attempting to form the letter T at the top of the movement. The elbow joints are under a ton of pressure from this full extension. It's never a good idea to lock out a joint during any activity.


Mistake 6: Locking Your Elbows in an L-Bend
It is a frequent misconception that if you bend your elbows strongly (approaching 90 degrees) as opposed to slightly, you can lift more weight during lateral raises. Yes, you can increase the weight, and yes, the range of motion in your upper arm will remain unchanged. But...

Physics' "lever arm" theory essentially states that a weight is harder to lift the farthest it is from your body. Consider that you can lift 35 pounds while performing lateral lifts with nearly completely extended arms. Then you begin performing the lifts with your arms bent at a 90-degree angle, and surprise, surprise, you can lift much more weight!

Try extending your arms a little further if you believe that the added weight indicates that you are becoming stronger. With that weight, are your reps still possible? Most likely not. That is physics' lever-arm law in action.
 

starboy

V.I.P.
Moderator
gearpic.jpg


Larger delts are a top priority for all lifters since they give the appearance of a smaller waist, enhance the separation of the upper arm from the lower arm, and add the type of shoulder cap that indicates you're a serious lifter. Your clothes' slight added stretch too, perhaps? That is what I'm referring to!

You might be beginning your shoulder workout with overhead presses like many lifters do. It works. The greatest technique to isolate the middle delts in the lateral (side) plane, however, is to include lateral-raise exercises.

Lateral raises are hugely popular, and frequently doing them incorrectly in several ways. Here are 6 ways to mess up the standing dumbbell lateral raise, the most popular variant.


Mistake 1: Altering the Angle of Your Elbow Throughout the Movement
When performing a lateral raise correctly, you should bend your elbows just slightly and keep them bent for the duration of the set. Your elbows should maintain the same angle at the peak and bottom of each rep.

The isolation of the middle-delts will be compromised if you begin opening and closing at the elbows, which will involve the triceps. The weights should ideally follow more of an arc as you raise them rather than a straight line. Watch yourself or have someone else watch you while you make this action; if you're paying attention, it's not difficult to fix the mistake.


Mistake 2: Lowering the Weight Too Low
Keeping the middle delts tense during each rep is the best strategy to develop these target muscles. You are not placing any stress on your delts at all if you lower your hand all the way down till it is hanging by your side or in front of your leg.

Furthermore, the supraspinatus, a rotator cuff muscle, starts the movement before the middle delt head when you begin lifting from this fully extended position. This indicates that your target muscles aren't being worked during the initial degrees of your raise.

Stopping the movement with your hand a few inches from your side is your best option. This will make it little more difficult to bring the weight back up, which is what you want, right? Lower the weight all the way if you do want to work your supraspinatus a little. But when you lift it again, watch out for using too much force or moving erratically, both of which might result in harm.


Mistake 3: Leading with Your Wrists
Beginners frequently make the error of wagging the weights up and down without extending their elbows. In that regard, the upper arms don't have a wide range of motion, which can negate your gains in the middle delts. You should constantly "lead with your elbows" to ensure that they complete the whole range of motion.

The advantages of this middle-delt movement are essentially lost if your elbows don't move much. Your elbows are only approximately halfway up, even though your hand is where it should be at the top. Always lead with your elbows, okay?


Mistake 4: Only Raising to Shoulder Height
Even though the middle delt's range of motion extends further aloft, people typically do lateral lifts to a height of roughly shoulder height. You can increase the amount of contraction in your middle delts by going up to a point about 45 degrees above parallel. (You'll also somewhat activate your upper traps.)

You'll probably need to reduce your weight when you can move above your shoulders. You might think about doing a few sets with bigger weights at shoulder level, then a few more with somewhat lighter weights at a 45-degree angle above parallel.

Lifting above your shoulders is usually not a smart idea if you have shoulder impingement or soreness. If this is a problem, consult a sports medicine physician before attempting to increase your range of motion.


Mistake 5: Extending Your Arms Fully While Locking Them
On rare occasions, you'll see someone performing lateral lifts with their arms fully extended. It appears as though the individual is attempting to form the letter T at the top of the movement. The elbow joints are under a ton of pressure from this full extension. It's never a good idea to lock out a joint during any activity.


Mistake 6: Locking Your Elbows in an L-Bend
It is a frequent misconception that if you bend your elbows strongly (approaching 90 degrees) as opposed to slightly, you can lift more weight during lateral raises. Yes, you can increase the weight, and yes, the range of motion in your upper arm will remain unchanged. But...

Physics' "lever arm" theory essentially states that a weight is harder to lift the farthest it is from your body. Consider that you can lift 35 pounds while performing lateral lifts with nearly completely extended arms. Then you begin performing the lifts with your arms bent at a 90-degree angle, and surprise, surprise, you can lift much more weight!

Try extending your arms a little further if you believe that the added weight indicates that you are becoming stronger. With that weight, are your reps still possible? Most likely not. That is physics' lever-arm law in action.
dont lock out your arms too much
 

QuadSweep

Top 5 Jr. USA Lt/hvy weight
Red
i actually follow all these steps myself
 
Similar threads
Thread starter Title Forum Replies Date
Richardbrown Napsgear: 5 COMMON CAUSES OF JOINT PAIN Steroids and SARMS 13
Richardbrown Napsgear: Common Stretching Mistakes and 9 Stretches to Get Started Steroids and SARMS 17
Richardbrown Napsgear: The Most Common Face Pull Mistake Steroids and SARMS 14
Q Need help with napsgear cycle and PCT Steroids and SARMS 11
Richardbrown NapsGear PROMO : 30% OFF ON HEMI PHARMA! Steroids and SARMS 10
Richardbrown Lab Tested, NapsGear Approved: SixPex Labs is Here Steroids and SARMS 14
Richardbrown Napsgear Product of the Week: Enantat 250 (Dragon Pharma) 50% Off Now! Steroids and SARMS 15
Jack Grey NapsGear Weekend Sale Will Begin on Jan 28, 2023...! Steroids and SARMS 14
Richardbrown NapsGear AMA - Guy Cisternino : Podcast #29: I'll just do it myself! Steroids and SARMS 14
F How is napsgear anavar? Steroids and SARMS 18
Richardbrown AAS Diaries From Napsgear Steroids and SARMS 12
H Napsgear getting bigger Steroids and SARMS 16
Richardbrown Napsgear: Does the EC Stack Become Ineffective? Steroids and SARMS 13
Richardbrown Napsgear Product of the Week: Anavar 10 (Dragon Pharma) 50% Off Now! Steroids and SARMS 13
K Loving my napsgear cycle Steroids and SARMS 18
Richardbrown NapsGear Weekend Sale Will Begin on Jan 21, 2023...! Steroids and SARMS 13
Richardbrown AAS Diaries From Napsgear Steroids and SARMS 13
Richardbrown Live Q&A with NapsGear Customers Steroids and SARMS 14
Richardbrown Napsgear: Share Gear Pics for Store Credit Steroids and SARMS 13
Richardbrown Napsgear Product of the Week: Primobolan 200 (Dragon Pharma) 50% Off Now! Steroids and SARMS 14
U Napsgear pack just arrived Steroids and SARMS 17
I Crazy good libido on napsgear Steroids and SARMS 18
Richardbrown NapsGear Weekend Sale Will Begin on Jan 14, 2023...! Steroids and SARMS 14
Richardbrown NapsGear AMA - Evan Centopani : Podcast #85:Treat your kidneys with respect! Steroids and SARMS 13
Richardbrown AAS Diaries From Napsgear Steroids and SARMS 14
G Napsgear oral run for 6 weeks Steroids and SARMS 17
Richardbrown NapsGear: Avoid These Foods Before Your Workout Steroids and SARMS 14
Richardbrown NapsGear GEN-SHI Lab Promo! Steroids and SARMS 14
V Napsgear sustanon options Steroids and SARMS 17
J Napsgear Very satisfied Steroids and SARMS 18
Richardbrown NapsGear Weekend Sale Will Begin on Jan 07, 2023...! Steroids and SARMS 13
Richardbrown AAS Diaries From Napsgear Steroids and SARMS 13
Richardbrown NapsGear AMA - Guy Cisternino : Podcast #25:No Gains, No Fame Steroids and SARMS 13
Richardbrown Napsgear: 8 Signs of Overtraining Steroids and SARMS 15
Richardbrown Napsgear Product of the Week: Trenbolone 200 (Dragon Pharma) 50% Off Now! Steroids and SARMS 13
Richardbrown NapsGear Weekend Sale Will Begin on Jan 07, 2023...! Steroids and SARMS 13
S napsgear dbol cheap and effective! Steroids and SARMS 17
Richardbrown NapsGear AMA - Lee Priest : Podcast #32:The Fast and the Furriest Steroids and SARMS 14
Richardbrown Napsgear Product of the Week: Deca 300 (Dragon Pharma) 50% Off Now! Steroids and SARMS 14
F Napsgear 2 steroids at a time Steroids and SARMS 16
Richardbrown You have a gift from NapsGear! Steroids and SARMS 14
Richardbrown NapsGear Christmas and New Year Mega Sale Steroids and SARMS 14
Richardbrown Napsgear: The Role of Genetics in Bodybuilding: What You Need to Know Steroids and SARMS 13
Richardbrown NapsGear Weekend Sale Will Begin on Dec 24, 2022...! Steroids and SARMS 14
Richardbrown AAS Diaries From Napsgear Steroids and SARMS 13
Richardbrown Napsgear: The Brachialis Handbook Steroids and SARMS 13
Richardbrown Napsgear Product of the Week: Cypionat 250 (Dragon Pharma) 50% Off Now! Steroids and SARMS 12
Richardbrown NapsGear Weekend Sale Will Begin on Dec 17, 2022...! Steroids and SARMS 1
Q Best napsgear testosterone? Steroids and SARMS 16
Richardbrown Napsgear Product of the Week: Supersus 400 (Pahrmaqo Labs) 50% Off Now! Steroids and SARMS 14

Similar threads

Top